Felt Roof Flashing

Flashing tape is a waterproof flashing membrane that is used to seal openings in exterior walls preventing moisture from entering the area.

Felt roof flashing.

Fasten drip edge on eaves with. At the end of the vertical sidewall the step flashing shall be turned out in a manner that directs water away from the wall and onto the roof and or gutter while this is a nice diagram of how these flashings work don t forget our 5 th design rule. Although roof flashing is occasionally fabricated from plastic roofing felt or rubber it is usually made of rust resistant metal galvanized steel aluminum or copper. Nail metal drip edge flashing which bends over the roof and down the edge of the facing board on all roof edges.

Galvanized sheet metal is most common but aluminum and copper find occasional use in specialty situations. Installing roof felt is a two person job. Flashing is installed to surround roof features such as vents chimneys and skylights. The flashing shall be a minimum of 4 inches 102 mm high and 4 inches 102 mm wide.