First Course Of Bevel Siding

One edge has a thick butt while the other edge is thinner.

First course of bevel siding.

Each succeeding course overlaps the one below. Clapboards have a triangular cut. Siding may be installed starting with the bottom course. Each succeeding course overlaps the upper edge of the lower course.

Make sure the first course is level. On rabbeted bevel siding leave a 1 8 inch expansion clearance. Carefully slide the notched piece of siding into place. Bevel wood siding provides rustic warmth for homes and log cabins.

The rabetted bevel dolly varden pattern features a 1 2 3 4 notch in the thicker butt end of the board this rabbeted edge cut allows the bevel siding panels to fit together in such a way as to protect joints from water infiltration. Thinner at the top and wider near the lower more exposed part of the board. Western red cedar bevel siding is the most widely used siding type. The manufacturing process results in pieces with one face saw textured.

The number of board spaces between the soffit and bottom of the lowest piece of siding at the foundation should be such that the overlap is as per the table. This is the first of a 2 part series. When installed it is nearly impossible to tell the difference between dolly varden and bevel or clapboard siding. They are lapped to shed water.

The dolly varden rabbeted bevel profile is an easier install while providing the same traditional bevel style and appearance. It is normally blocked out with a starting strip the same thickness as the top of the siding board see figure a. It is produced by resaying lumber at an angle to produce two pieces thicker on one edge than the other. Bevel siding also referred to as clapboard siding is a very popular wood siding product.

Join the clapboards with scarf joints as in step 3. Installing bevel siding clapboards spacing for the siding should be laid out beforehand. Click here to read a short course on cladding part 2. Step 8 siding beside windows photo by david carmack.

If more than one clapboard is needed to span a wall snap a chalk line between the marks on the corner boards on top of the course being overlapped. Align the bottom of the bevel plank with the bottom of the starter strip with the end flush against the trim and. It is lumber that has been resawn at an angle resulting in two pieces. Nail the clapboard to the studs.

The most familiar type of wood siding is the clapboard a form of lap siding that s also called bevel siding. Siding should be nailed to each stud or on 16 inch centers. Place the nail just above the overlap. Set the first bevel board in place against the trim at a corner of the house.

With dolly varden siding you get the appearance of bevel and clapboard siding but the convenience of self spacing thanks to the rabbet at the bottom to accept the top of the preceding course.